Mötande tåg - Svenska 3D-Tåg

**Fredrik** · 2003-12-02, 15:58

Det går att tala om hur bra AI-tågen ska köra.

När du är i "service editorn" kan du under "Expected player performance" sätta ett värde från 1 till 100.

I hjälpen till editorn kan man läsa följande

Expected Player Performance

The expected player performance is the efficiency with which the player is expected to operate the train. This value is expressed as a percentage of perfection. So, for example, 100% efficiency would indicate that you expect the player to operate the train at an optimum level from the moment the Activity starts until completion. This would allow no room for error whatsoever.

A performance level of 50 - 60% is a good guideline for most users. A beginning engineer attempting a very difficult Activity would likely operate at less than 50% while a seasoned veteran might operate at 75 to 85%.

The expected efficiency is used primarily to calculate traffic patterns. When you use the time acceleration model to check your Activity the Player Service runs at the rate you set in the Expected Player Performance field.

___________________________________
Fredrik
Admin Svenska 3D-Tåg
Regler

Liknande ämnen
Ämne	Startat av	Forum	Svar	Senaste inlägg
HJÄLP får inte igång min rutt :o(	Trigger	MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails	10	2003-01-06 16:56
Mötande tåg	Dson	Landskapsdesign - MSTS / Open Rails	9	2003-01-06 15:08
Mötande tåg i aktiviteter	Rogge	MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails	4	2002-09-30 16:54
mötande tåg	Dson	MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails	2	2002-09-03 19:31
Önskar hjälp med mötande tåg.	Lasse Eldare	MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails	3	2002-07-24 15:14

2003-12-02, 15:58	#1
Fredrik Admin & STW-member Reg.datum: Aug 2001 Ort: , , Sweden. Inlägg: 5 814	Det går att tala om hur bra AI-tågen ska köra. När du är i "service editorn" kan du under "Expected player performance" sätta ett värde från 1 till 100. I hjälpen till editorn kan man läsa följande Expected Player Performance The expected player performance is the efficiency with which the player is expected to operate the train. This value is expressed as a percentage of perfection. So, for example, 100% efficiency would indicate that you expect the player to operate the train at an optimum level from the moment the Activity starts until completion. This would allow no room for error whatsoever. A performance level of 50 - 60% is a good guideline for most users. A beginning engineer attempting a very difficult Activity would likely operate at less than 50% while a seasoned veteran might operate at 75 to 85%. The expected efficiency is used primarily to calculate traffic patterns. When you use the time acceleration model to check your Activity the Player Service runs at the rate you set in the Expected Player Performance field. ___________________________________ Fredrik Admin Svenska 3D-Tåg Regler