![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
Register | Members Area | FAQ | Members List | Community-ware/Modell-shop | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
![]() |
#1 |
Medlem
Join Date: Aug 2002
Posts: 838
|
![]()
När jag kommer hit i volkers turital får jag det aldrig rätt hur ska ja göra...
"The upper vertices are selected. In the dialog box Absolute World Z we type in the value 1.5 and press enter. The upper side of the box is moving to 1.5 meter above zero. Caution! To type in decimal values with a point as a decimal separator or a comma, as we do in Germany, might depend on the language setting of your computer. we select vercices and type in the values as follows: The lower vertices to Z 0.5 meter The front vertices toY 4.5 meter (to be selected in the Top viewport) the rear vertices to Y -4.5 meter (to be selected in the Top viewport) The right vertices to X 0.65 meter (to be selected in the Front viewport) The left vertices to X -0.65 meter (to be selected in the Front viewport) The box may appear very small now. Therefore we have to zoom in with the view control: " //John |
![]() |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ritning som underlag ? (Gmax) | sjonas | Off-topic | 6 | 01-07-2006 11:29 AM |
Gmax info | Pierre | 3D-design/Ommålningar - MSTS / Open Rails | 3 | 05-31-2003 04:56 PM |
Jag behöver hjälp! Snälla hjälp mig! | ghost | MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails | 3 | 05-12-2003 07:06 PM |
Får ja ingen hjälp får det bli så här...[Och nu bl | prymikom | 3D-design/Ommålningar - MSTS / Open Rails | 24 | 01-03-2003 06:18 PM |
Lyckats fått in min V5:a i GMax!!! | Zzarr | 3D-design/Ommålningar - MSTS / Open Rails | 17 | 10-22-2002 01:33 AM |