Svenska 3D-Tåg - Forum - Visa ett inlägg

2006-10-08, 21:53

Hittade lösningen:

2. 'I receive Error 429 whenever I try to Check a Route or do some other functions in Route-Riter'.

The error 429 has always been caused by problems with either .Net or the Tokens not being registered properly.

This is caused when the .dll required to compress/uncompress files is not installed properly.

1. Make sure that you have Microsoft .Net Framework v1.1 installed (go Control Panel/Add Remove programs to see if it is listed).
2. Make sure that TK.MSTS.Tokens.dll and .tlb are both in the Route-Riter folder along with regasm.exe and InitTokens.bat
3. Click on InitTokens.bat – this should take up to 5-10 mins to uninstall the old tokens, Then hit any key and it will install the new ones.
4. This should then tell you the tokens are installed, after which RR should run OK.

2006-10-08, 21:53	#742
Byggare Bob Guest Inlägg: n/a	Hittade lösningen: 2. 'I receive Error 429 whenever I try to Check a Route or do some other functions in Route-Riter'. The error 429 has always been caused by problems with either .Net or the Tokens not being registered properly. This is caused when the .dll required to compress/uncompress files is not installed properly. 1. Make sure that you have Microsoft .Net Framework v1.1 installed (go Control Panel/Add Remove programs to see if it is listed). 2. Make sure that TK.MSTS.Tokens.dll and .tlb are both in the Route-Riter folder along with regasm.exe and InitTokens.bat 3. Click on InitTokens.bat – this should take up to 5-10 mins to uninstall the old tokens, Then hit any key and it will install the new ones. 4. This should then tell you the tokens are installed, after which RR should run OK.